This file describes normal monitor installation procedures for
Windows 95 and Windows 98. Use these procedures when installing
Likom monitors.
Plug & Play (DDC) monitor INSTALLATION PROCEDURE
If your display adapter and driver support Plug & Play
the DDC monitor will be automatically detected and installed
as a "VESA DDC compatible monitor" by Windows 95 at startup.
If it is not, then follow the procedure for manual installation below.
MANUAL MONITOR INSTALLATION PROCEDURE
1. Click the "Start", point to the menu "Settings", then click
the "Control Panel".
2. In the "Control Pannel" windows, double click the "Display" icon.
3. In the "Display Properties" windows, click the "Settings" tab.
4. Click the "Advanced Properties" button.
5. In the "Advanced Display Properties" windows, click the "Monitor" tab.
6. Click the "Change..." button.
7. Click the "Have Disk..." button on the "Select Device" window.
8. Specify the path to the INF file and press the ENTER
key:
Example 1: Insert the disk in the A: floppy drive,
and enter A:\.
Example 2: Type in the name of the directory where you copied
the INF file, either on your local hard drive or
on a network share.
Example 3: If you're not sure exactly where the INF file is,
choose the "Browse..." button to find file.
9. Click "OK" button then back to the "Select Device" window.
10. Click on the "Show All Devices" in "Select Device" window.
11. Select your monitor model from the list and then click "OK".
12. Click the "Close" button on the "Advanced Display Properties" to return
to "Display Properties".
13. If system pop-up a "Refresh Rate" message box, click on the "OK" button.
14. Click on the "OK" button from the "Display Properties" windows to finish
the monitor setting.
|
